The Superrollo radio tubular motors can be operated with the ST110 or ST115 transmitter.
ST110 ST115
Registering the remote control to the motor (motor on the right)
If the motor is installed on the right side of the roller shutter box, establish the radio connection between the motor and the remote control in this way.
➢Switch off the motor.
➢Wait approximately 10 seconds.
➢Switch the motor on again.
You will hear a long beep starting from the motor.
➢Press the P2 key next to the battery compartment on the back of the remote control twice.
➢Press the UP key once.
You will hear seven short beeps starting from the motor.
Logging the remote control onto the motor (motor on the left)
If the motor is installed on the left side of the roller shutter box, establish the radio connection between the motor and the remote control in this way.
➢Switch off the motor.
➢Wait approximately 10 seconds.
➢Switch the motor on again.
You will hear a long beep starting from the motor.
➢Press the P2 key next to the battery compartment on the back of the remote control twice.
➢Press the DOWN key once.
You will hear seven short beeps starting from the motor.
Registering another remote control on the motor
To register another remote control to the motor, proceed as follows
:➢Switch on the motor.
➢Wait approximately 10 seconds.
➢Press the P2 key twice on the already registered remote control.
Press the P2 key once on the remote control that is now to be registered.
You will hear five short beeps starting from the motor.
Logging off the remote control
To log off a remote control from the motor, proceed as follows
:➢Switch on the motor.
➢Wait approximately 10 seconds.
➢Press the P2 key once on the remote control to be deregistered.
➢Press the STOP key on the remote control.
Press the P2 key on the remote control once.
You will hear four short beeps starting from the motor.
Comments
0 comments
Please sign in to leave a comment.