The remote control cannot be registered. The belt winder does not respond to the remote control.

The receiver is not completely inserted into the belt winder.

When inserting the receiver into the slot, you must overcome a small resistance until the receiver locks into place. Pull the receiver out again and plug it in again.

Set the upper and lower end points according to the operating instructions.

Without end points, the belt retractor does not respond to the remote control.

Carry out a new registration.

1. Press the sun and UP key for 4 seconds until the sun LED flashes green.
2. Select the desired channel on the transmitter.
3. Press UP key
4. Sun LED stops flashing.