Registering the radio hand-held transmitter:
In order for the ZB60 radio receiver to respond to control commands from the hand-held transmitter, it is essential to set both end points on the belt retractor in advance.
- Press the sun and open buttons on the belt retractor simultaneously for 4 seconds until the sun indicator lamp on the belt retractor flashes. The radio receiver in the belt retractor is now in registration mode for 60 seconds.
Note! If the sun control lamp does not flash after 4 seconds, the maximum number of 4 handheld radio transmitters has been reached. - Use the following keys to select the channel on the radio hand-held transmitter.
- In the last step, press any command button on the handheld radio transmitter. As soon as the sun control lamp stops flashing, the radio hand-held transmitter is registered on the selected channel (1 - 3).
Logging off the radio hand-held transmitter:
- Press the sun and down buttons on the belt rewinder simultaneously for 4 seconds until the clock indicator light of the belt rewinder flashes. The radio receiver in the belt rewinder is now in logout mode for 60 seconds. The radio receiver in the belt rewinder is now in logout mode for 60 seconds.
Notice. If the clock control lamp does not flash after 4 seconds, all radio handheld transmitters have already been logged off. - Use the following keys to select the channel on the handheld radio transmitter.
- In the last step, press any command button on the handheld radio transmitter. As soon as the clock control lamp stops flashing, the handheld radio transmitter is
logged off at the selected channel
(1 - 3).
Logging off all hand-held radio transmitters simultaneously:
It is also possible to log off all hand-held radio transmitters at once by resetting the belt winder to the factory settings.
To do this, press the following buttons on the belt rewinder simultaneously for 4 seconds until both control lamps of the belt rewinder flash.
By resetting the belt winder to the factory settings, all registered radio hand-held transmitters are logged off from the radio receiver. Carry out the basic settings of the belt winder again and follow the instructions in the operating manual.
Comments
0 comments
Please sign in to leave a comment.